MA-COM MACOM H360 Circulator Isolator UHF 450-470MHz Tuneable with 30Watt Load

Description

one
used M/A-COM MACOM H360 Circulator Isolator in UHF Band tuned to 450-470MHz, But Tuneable over the range of 406 to 512 Mhz. Includes one Celwave 30Watt Load. Every unit tested to meet factory specs. Insertion loss of 0.4 dB typical.  All units have N-Type connectors. Actual photos show some blemishes, but are fully functional. Single units shipped First Class at cost and two or more will be shipped Priority Mail.
See my listing in other frequency ranges or with other loads.  We also have 3 db Hybrid couplers to build transmitter combiners.
Shipped center tuned to 462.5 MHz, UNLESS you request a specific frequency prior to shipment
Some people ask if a 30 watt load is enough?  The vast majority of users are fine with the 30 watt load on a 100 watt repeater. One possible exception, should the coax cable short near the transmitter while operating at a high duty-cycle such as paging, you would need a 100 watt load. But most repeaters operate intermittent and most failures occur at or near the antenna. For example, if your feedline loss is 1.5 dB to the antenna and your antenna failed, with an VSWR of 10:1 with 66% of the power reflected. Then you are losing 29% [1.5dB] of your power reaching the antenna and the bad antenna is reflecting 66% back down the feedline for another 25% feedline loss for a total of 33 intermittent watts into the 30 watt load. With that bad of antenna, few users would be using the repeater. If your feedline loss is slightly greater at 2 dB, then even with a dead-shorted antenna, you could never exceed 36 watts returned to the load.